Worksman PAV3 With 2 speed Honda and Statton Drive

Overview

PAV3 Two Speed. Honda GXH50 49.3cc 2.50 hp Four Cycle engine and Gear & Chain Drive Kit. This gear and chain drive kit mounts under the seat of the PAV3. You can move the seat front and back and have full use of the basket. You can start the engine from the seated postition. No drilling or welding of the frame. It freewheels when coasting so you have ZERO drag. You can use the rear coaster brake and change gears when you pedal.

Description

PAV3 Two Speed with the Honda GXH50 49.3 cc 2.50 hp Four Cycle engine and Gear & Chain Drive Kit.

This gear and chain drive kit mounts under the seat of the PAV3.

You can move the seat front and back and have full use of the basket.

You can start the engine from the seated postition.

No drilling or welding of the frame.

It freewheels when coasting so you have ZERO drag.

You can use the rear coaster brake, single speed coaster brake or the 3 speed coaster brake and change gears when you pedal. You can use the engine and pedal or any combination. What is nest about this drive system is that you have a two speed. The gear box has Dual output shafts, one on each side of the gear case.

The low range is chain driven and uses a freewheel sprocket on adaptor. The adaptor is placed on the axle and this makes you 1st - low gear. You have a ton of pulling power to pull heavy loads up very steep hills or if you have to go off road the low range will give you the power to pull most any hill or load.

The unit will always be low until you shift it into the 2nd range - high. The 2nd range uses a “V” belt drive. The pulley is attached to a freewheeling clutch, it’s attached to the adaptor to fit the axle. Lift up on the lever to tighten up the belt, then the axle is turned at a higher ratio to give you the faster 2nd range. The chain still turns, but it’s on a freewheel so the belt drive over runs it. Lower the lever to release the tension on the belt and your back in the low range. The two speed system works GREAT and it allows a smaller engine size to be used and still pull the steep hills and / or a very heavy load up to 500+ lbs. The 2nd range is great for going faster on pavement.





3" rear Tires

1000.00 for the trike 870.00 for the Kit 130.00 for the install

In stock and ready for shipment with or without motor.

Ships freight in a wooden crate fully assembled